Default Value : 1

Select an ID for the unit's remote controller from "1", "2", and "3" to prevent interference between the unit and other Onkyo components that are installed in the same room. After changing the ID on the main unit, change the ID on the remote controller accordingly with the following procedure.

1.While holding down RCV, press Q SETUP for about 3 seconds until the remote indicator lights.

2.With the number buttons, press one of 1, 2, and 3. The remote indicator flashes twice.

Default Value : –

Input and register the remote controller code of other devices.

 For registration of the remote control code, refer to "Operating Other Components Using Remote Controller".