Troubleshooting

Resetting the unit

Resetting the unit to the status at the time of shipment may solve the problem. If the measures above do not solve the problem, reset the unit with the following procedure. If you reset the unit status, your preferences will be reset to the defaults. Note them down before starting reset.

How to reset

1.While holding down CBL/SAT on the main unit (note that step 2 must be performed with this button pressed down)

2.Press 10671.pngON/STANDBY on the unit. “Clear” is appeared on the display and the unit will enter standby mode.

10681.png

How to reset the remote controller

1.While holding down 1RECEIVER on the remote controller (note that step 2 must be performed with this button pressed down)

2.Press and hold down 2HOME until the 1RECEIVER button lights (about 3 seconds). Within 30 seconds, press 1RECEIVER again.

18640.png

SN 29401690HTML_EN
(C) Copyright 2014 Onkyo Corporation Japan. All rights reserved.