Firmware Update

Updating the Firmware via USB

Before Start:

 Prepare a 64 MB or larger USB storage device.

Media inserted in a USB card reader may not be used for this function.

USB storage devices with security function are not supported.

USB hubs and USB devices with hub function are not supported. Do not connect these devices to the unit.

 Delete any data stored on the USB storage device.

 Turn off the controller component (PC etc.) connected to the network.

 Stop any playing Internet radio, USB storage device, or server content.

 If the multi-zone function is active, press OFF on the main unit to turn it off.

 If "HDMI CEC (RIHD)" is set to "On", set it to "Off" (default value).

After pressing RECEIVER, press HOME on the remote controller. Select "Setup" with the cursors and press ENTER. Then, after selecting "7. Hardware Setup" - "HDMI" and pressing ENTER, select "HDMI CEC (RIHD)" to select "Off".

Some USB storage devices may take long to load, may not be loaded correctly, or may not be correctly fed depending on the device or their content.

Onkyo will not be liable whatsoever for any loss or damage of data, or storage failure arising from the use of the USB storage device with this AV receiver. Thank you for your understanding.

The description may differ from the on-screen display but that will not change the way to operate or the function.

Update

If an Error Message is Displayed

SN 29401690HTML_EN
(C) Copyright 2014 Onkyo Corporation Japan. All rights reserved.