Connect an Onkyo component with RI jack to this unit using an RI cable and an analog audio (RCA) cable. For details, refer to the instruction manual of the component with RI jack. The RI cable can be connected in any order. When there are two RI jacks, both jacks work in the same way and are interchangeable.
To connect the RI Dock or cassette tape deck via RI, you must:
To make the RI functions work, you must rename the input selectors on the unit. Press TV/CD or GAME to display "TV/CD" or "GAME" on the main unit display. Then press and hold TV/CD or GAME 3 seconds or more to switch the display to "DOCK" or "TAPE".
Program the remote control code to any REMOTE MODE button on the remote controller. This will allow you to operate the component by pointing the remote controller at the unit instead of the component.
1.Press DISPLAY for 3 or more seconds while holding down the REMOTE MODE button to which you want to program the remote control code.
The REMOTE MODE button stays lit.
The RECEIVER, ZONE and TV buttons cannot be programmed.
2.With the number buttons, enter the following 5-digit remote control code within 30 seconds.
RI Dock: 81993
Cassette tape deck with RI jack: 42157
Programming is complete when the REMOTE MODE button flashes twice. The REMOTE MODE button flashes once slowly when programming the remote control code fails. Try registering again.
Input selector on the RI Dock: Select "DOCK" or "TAPE". For details, refer to the RI Dock's instruction manual.
To operate Onkyo components directly or Onkyo components that are not connected via RI, use the following remote control codes:
Onkyo DVD player: 30627
Onkyo CD player: 71817
RI Dock: 82990
With some models, operation may be not possible in part or not possible at all.