Operating Other Components with the Remote Controller

Assigning Another Device's Remote Controller Functions to the Unit's Remote Controller

If you want to add some functions after registering a remote control code to the REMOTE MODE button, you can assign the desired button of the unit's remote controller to learn the functions of another device's remote controller. You can assign only one function in one procedure.

1.While holding down the REMOTE MODE button to which you programmed the remote control code of the other device to be learned, press and hold 19880.pngRECEIVER about 3 seconds until the REMOTE MODE button stays lit.

19392.png

2.Press the desired button of the unit's remote controller that you want to assign.

 The 20622.pngRECEIVER, ZONE, ACTIVITIES, REMOTE MODE/INPUT SELECTOR, and REMOTE (MODE, TV, RECEIVER) buttons cannot learn functions:

3.Face the remote control sensor of the other device with that of the unit and put the remote controllers within 10 cm from each other.

20556.png

4.On the other device's remote controller faced to the unit's remote controller, hold down the desired button you want to assign to the unit's remote controller.

Assignment is complete when the REMOTE MODE button flashes twice.

 If you assign more functions, repeat steps 2 to 4.

5.To end assigning, press REMOTE MODE button.

The REMOTE MODE button flashes twice.

 If assignment is made on a button to which you already assigned a function, the function will be overwritten.

 The remote controller of the unit can learn 70 to 90 functions.

 The remote controller of the unit uses infrared ray. It may not be possible to transfer the codes from some remote controllers due to difference of their transfer system. Also assignment may not be possible and the intended operations may not be achieved depending on the remote controller.

To clear the learned function: While holding down the REMOTE MODE button to which you assigned the function to be cleared, press and hold TV about 3 seconds until the REMOTE MODE button stays lit.

19400.png

To clear all the learned functions, press the REMOTE MODE button again. If you clear the function of any of the buttons, press the desired button. The REMOTE MODE button flashes twice and the learned function is cleared.

SN 29401690HTML_EN
(C) Copyright 2014 Onkyo Corporation Japan. All rights reserved.